Laser cutting machine is the use of laser strong energy type, the die board for high depth ablation, so as to achieve the purpose of cutting, belongs to the high-precision equipment, Laser cutting machine has the following characteristics, simple design,high precision, high efficiency, cheap, YITAI precision machinery will introduce a few points of maintenance you should pay attention!
In fact, if you want to maintain laser cutting machine, you should pay attention to 5 things
1、Every time after using the laser cutting machine, you must clean the machine and guide dirt, so that the bed to keep clean, and spray lubricant.
2、Clean up the waste in time, keep the vent airflow smooth.
3、Keep a regular cleaning of the chiller once, drain the dirty water in the machine, and then fill up with new pure water.
4、Check the cable line frequently to ensure that the line is intact and not broken.
5、Timely check and repair the laser cutter die, find problems and repair in time to ensure that the equipment is in normal condition.
The specific maintenance schedule is as follows:
I. Routine maintenance and care
1. every working day must clean the machine and guide dirt, so that the bed to keep clean, at the end of the work day to turn off the air supply and power supply, and at the same time empty the machine tube with the remaining air.
2. If you leave the machine for a long time, turn off the power supply to prevent the operation of non-professionals.
3. pay attention to the machine horizontal and vertical guide rails and rack surface lubrication, so that it is well lubricated!
II. Weekly maintenance and upkeep
1. Check that the main air inlet is free of trash and that all valves and pressure gauges are working properly.
2. Check that all gas pipe joints are loose and all pipe straps are not broken. If necessary, tighten or replace them.
3. Check all transmission parts for looseness, check the gear and rack meshing, and adjust if necessary.
4. Loosen the tightening device, push the carriage by hand, whether to come and go freely, if there are abnormalities in time to adjust or replace.
5. Check the clamping block, steel belt and guide wheel have no loosening, steel belt tightening condition, adjust if necessary.
6. Check the power cabinet and operating platform, whether the fastening screws are loose, and clean the dust in the cabinet with vacuum cleaner or hair dryer. Check whether the terminals are loose.
7. Check the performance of all buttons and selector switches, replace damaged ones, and finally draw comprehensive testing graphics to test the accuracy of the machine.
Send an inquiry right now, our sales will reply with the price within 12 hours.
